How to factory reset Brocade FC Switch

login as root with password fibranne

switchdisable

configremoveall

yes to all

after reboot login again as root

passwddefault

login as admin

userconfig --change root -e yes

3PAR Port port:0:0:2 Port listed as host path but is State:ready, Mode:initiator and Type:rcfc

 Assuming, that RCFC is properly configured and Zoning is correct (Only the 2 RCFC Ports in the Zone).

To check this use: showportdev ns 0:2:2

You should see only the two RCFC WWN, so where are the Hosts come from?

The Issue is, that the Array holding a List of all Hosts ever seen on the Ports.

The message says, that on these ports Hosts are seen (also in the past), but it is an RCFC port that should not see Hosts.

Check the Host list with: servicehost list

Cleanup all old Hosts with: servicehost remove [-f 0:2:2]

Source